KZ EDX Pro X In-Ear Monitors
KZ EDX Pro X In-Ear Monitors
Your first in-ears · vocalists · a spare set in the gig bag
Pickup currently not available
Free NZ shipping · dispatched next working day from Mount Maunganui · shipping & returns
YOUR FIRST STAGE IEM
Hear your mix. Keep your focus.
The KZ EDX Pro X is a lightweight wired in-ear monitor with energetic bass, clear vocals and a secure over-ear fit. Suited to rehearsals, lessons and live monitoring.
ONE DRIVER, COHERENT SOUND
A super-linear dynamic driver delivers punchy lows and an easy-to-follow full-range mix.
READY FOR THE STAGE
Over-ear cable routing and passive isolation help the earpieces stay secure while you play.
BUILT TO KEEP GOING
A detachable 0.75 mm two-pin cable can be replaced instead of replacing the whole set.
Pick your colour
All four colours have the same sound and specifications.
One super-linear dynamic driver keeps the mix coherent
A single full-range diaphragm handles the entire signal, avoiding a crossover between different driver types.
Rhythm weight with vocal and guitar presence
The response lifts the lows for kick and bass cues, then brings the upper mids forward so vocals, guitars and attack remain easy to follow. A good ear-tip seal matters: a poor seal removes much of that low-frequency support.
Manufacturer measurement shown for comparison. Ear-tip seal, fit, ear anatomy and the source device all affect the response you actually hear.
Frequently asked questions
Is the EDX Pro X suitable as a first IEM?
Yes. Its lightweight shell, simple single-driver design and easy power requirements make it a practical first wired monitor.
Do the four colours sound different?
No. Black, Clear, Cyan and Grey use the same acoustic design. Only the finish changes.
Can I replace the cable?
Yes. Use a replacement cable made for a 0.75 mm two-pin KZ connection.
Why does the bass sound thin?
The most common cause is a poor ear-tip seal. Try another supplied tip size and make sure the earpiece sits securely.
Need more separation in a busy band mix? Compare the KZ ZS10 Pro X. For fit and safe setup, read the Band Factory IEM fit guide.
- Stocked in Mount MaunganuiDispatched the next working day
- Free NZ shippingTracked courier, 1–3 working days
- 12-month warrantyPlus your full Consumer Guarantees Act rights
- Pickup available40 Hewletts Road, by arrangement
Specifications
| Drivers | 1 × super-linear dynamic driver (per side) |
|---|---|
| Total driver count | 2 across both sides |
| Impedance | 23 ± 3 Ω |
| Sensitivity | 108 ± 3 dB |
| Frequency response | 20 Hz – 40 kHz |
| Sound signature | Warm and full — lifted bass, forward vocals |
| Cable | Detachable flat silver-plated cable |
| Cable length | 120 ± 5 cm |
| Connector | 0.75 mm 2-pin |
| Plug | 3.5 mm |
| Inline microphone | No — monitoring cable without an inline microphone |
| Best for | Your first in-ears · vocalists · a spare set in the gig bag |
In the box
- 1 × pair KZ EDX Pro X earphones
- 1 × detachable silver-plated cable (0.75 mm 2-pin, 3.5 mm)
- 3 × pairs silicone ear tips (S / M / L)
- 1 × user manual
Get the seal right first
If your in-ears sound thin or bass-light, check the fit. Try the three supplied tip sizes and wear the cable looped over your ear. The fit guide explains how to check the seal and what to try next.
Read the two-minute fit guide →